AC Safety Inspection

An Air Conditioner Safety Inspection is a basic check of the components in your AC. It aids in preventing major damage from fire and major part failure. Tests and inspection are listed below.

  • Test Blower on furnace
  • Capacitor on furnace
  • Coil cleanliness
  • Drainage condensate
  • Check refrigerant charge
  • Amp draw in outdoor unit
  • Test Capacitor on outdoor unit
  • Inspect AC lines for restrictions

Air Conditioner Maintenance

Routine maintenance of your Air Conditioner is VITAL to sustaining its efficiency and extending the life of your AC. We highly recommend a routine maintenance of your furnace and AC. We make that simple with our Silver Club Memberships.

AC Maintenance

Maintaining your AC helps to extend the life of your Air Conditioner. We recommend an annual maintenance to make sure that your system is running well to keep you nice and cool inside even during the Hot Idaho Summer Heat!

  • Blower Motor & Amp Draw
  • Check AC for Level
  • Motor Start Capacitor
  • Inspect AC Lines for Restrictions
  • Blower Motor on furnace inspection
  • Evaporator Coil inspection
  • Inspect Contactor
  • Freon Levels testing
  • Test compressor Amp Draw
  • All wiring connections inspected
  • Measure & Test Temperature Drop
  • Filter inspection
  • All Wiring Connections inspection
  • Measure & Test Temperature Rise
  • Inspect Coil for Mold Like Debris
  • Condensate Drain inspection
  • Rinse Condenser Coil
  • Spray Off Outdoor Unit
  • Efficiency Performance Analysis
  • Lubricate Motor (if needed)
  • Level & Clean Thermostat

AC Super Tune Up

This extreme cleaning of your Air Conditioner includes cleaning both the indoor and outdoor coil along with the following:

  • Test Blower Motor & Amp Draw
  • Check AC for Level
  • Test Motor Run Capacitor
  • Inspect AC Lines for Restrictions
  • Inspect Blower Motor on furnace
  • Inspect Evaporator Coil
  • Inspect Contactor
  • Test Freon Levels
  • Test compressor Amp Draw
  • Test All Wiring Connections
  • Measure & Test Temperature Drop
  • Check Filter
  • Check All Wiring Connections
  • Measure & Test Temperature Rise
  • Inspect Coil for Mold Like Debris
  • Inspect Condensate Drain
  • Rinse Condenser Coil
  • Spray Off Outdoor Unit
  • Efficiency Performance Analysis
  • Lubricate Motor (if needed)
  • Level & Clean Thermostat
  • Clean Indoor Coil
  • Clean Outdoor Coil

Call Us Today For A
Free Estimate !

208-608-5050

System Rejuvenation

Bring your system back into tip top shape! This is the ULTIMATE cleaning of your AC AND Furnace.

  • Inspection of Heat Exchanger
  • Test Blower Motor & Amp Draw
  • Test Inducer Motor Amp Draw
  • Test Start Capacitor
  • Inspect Blower Wheel
  • Inspect Evaporator Coil
  • Test Flame Sensor
  • Test for Proper Venting
  • Test Ignition System
  • Test for Gas Leaks
  • Test All Wiring Connections
  • Measure and Test Temperature Rise
  • Check Filter
  • Clean Burners
  • Clean Furnace Cabinet
  • Clean Motor Housing
  • Check Belts
  • Clean Flame Sensor
  • Set and Calibrate Gas Pressures
  • Clean Heat Exchanger
  • Lubricate Motor (if needed)
  • Level and Clean Thermostat
  • Clean Blower Wheel
  • Duct Inspection
  • Test and Calibrate Freon Levels
  • Check AC for Level
  • Test Motor Run Capacitor
  • Test Compressor Start Capacitor
  • Inspect AC Lines for Restrictions
  • Test Compressor Amp Draw
  • Inspect Breaker and Disconnect
  • Inspect Contactor
  • Clean Condensate Drain Line
  • Inspect Coil for Mold-Like Debris
  • Inspect Condensate Drain
  • Rinse Condenser Coil
  • Efficiency Performance Analysis
  • Clean Around Furnace
  • Inspect Indoor Air Quality Products